Content Comparison

Spray with Greaselift and let sit before scrubbing.

Use a dry cloth to wipe away any crumbs.

Use a scarper to remove any heavy carbon build up (Hot Tip - Don’t use a heavy scourer - that will scratch and damage it).

Fill impinger bath with hot water and Kays Degreaser (1/2 cup degreaser per 1ltr water). Soak crumb trays, end stops, airflow fingers and centre arms overnight.

Scrub using a nylon scourer, wipe over tracking, removing any carbon/grease build up. Using a hard bristled brush for the conveyor belt. For any stubborn build up, spray with Greaselift.

Rinse all parts with hot water and let dry before putting it back together.

Replace centre arms.

Replace airflow fingers by sliding components back in place ensuring holes are aligned.

Replace end plates on each side. Align the bottom first. Don't over tighten the screws.

Replace the conveyor belt. (Hot Tip - Make sure you have a second person to help).

Push back spring loaded drive hub and realign gear assembly with spring loaded drive hub.

Replace crumb trays.

Replace airflow panel.

Replace end stops.

Always recalibrate your impinger after cleaning! Check your timer and temperature.

Always wear the correct PPE.

Spray with Greaselift and let sit before scrubbing.

Use a dry cloth to wipe away any crumbs.

Use a scarper to remove any heavy carbon build up (Hot Tip - Don’t use a heavy scourer - that will scratch and damage it).

Fill impinger bath with hot water add Dip-It Plus powder (50g of Dip-It Plus per 5 litres of water). Soak crumb trays, end stops, airflow fingers and centre arms overnight (minimum 3 hours soaked).

Scrub using a nylon scourer, wipe over tracking, removing any carbon/grease build up. Using a hard bristled brush for the conveyor belt. For any stubborn build up, spray with Greaselift.

Rinse all parts with hot water and let dry before putting it back together.

Replace centre arms.

Replace airflow fingers by sliding components back in place ensuring holes are aligned.

Replace end plates on each side. Align the bottom first. Don't over tighten the screws.

Replace the conveyor belt. (Hot Tip - Make sure you have a second person to help).

Push back spring loaded drive hub and realign gear assembly with spring loaded drive hub.

Replace crumb trays.

Replace airflow panel.

Replace end stops.

Always recalibrate your impinger after cleaning! Check your timer and temperature.

Always wear the correct PPE.